Use this calculator to find fabric requirements and cutting instructions for any of your AccuQuilt 8″ Qube Mix & Match dies. Simply choose the die and enter the number of finished units you want.
This page includes all 8 dies from the 8″ Mix & Match set.
AccuQuilt 8″ Qube Companion Sets
Check out the 8″ Qube Companion Sets
AccuQuilt 8″ Mix & Match Qube Calculators
Cutting measurements are taken from theย AccuQuilt.comย website under theย DETAILSย tab for each individual die.
NOTE: Although we take great care to get the information, numbers and calculations right, we are not responsible for errors on this platform. It is strongly suggested you make test cuts and test piecing before cutting your entire project.
4″ Finished Square
55708
2″ Finished Squares 55709
For the HST units made from Shape 3, you will need two different fabrics: the background and the accent. The results below show fabric requirements for one of those fabrics. You will need an equal amount of the other fabric to make the number of HST units you require.
4″ Finished HST 55710
For the QST units made from Shape 4 you will need 4 squares for 4 QST units.
The results from this calculator will be for 1 of those squares. You will need the same amount for each of the other 3 squares.
4″ Finished QST 55711
For the HST units made from Shape 5, you will need two different fabrics: the background and the accent. The results below show fabric requirements for one of those fabrics. You will need an equal amount of the other fabric to make the number of HST units you require.
4″ Finished Square on Point 55713
2″x4″ Finished Rectangle 55715
Remember to sign up for our Friday newsletter to be notified of new content here at The Quilt Calculator.
Happy quilting!
4 responses to “AccuQuilt GO! Qube Mix & Match 8″ Block”
-
Love my Accuquilt. Thanks for the help in calculating fabric requirements!
-
My pleasure!
-
-
Great calculator, will you be doing one for the 9 inch qube?
-
I plan to do one for each of the Qubes, however I need to get the measurements of all the others. I only have the 6 and 8 inch qubes. Since you asked, I’ll work on the 9″ Qube next. Do you have the Companion Angles and/or Corners for the 9″? If so, would you be willing to measure some of the dies for me?
-
Leave a Reply